|
Flaps, Page 2, (click on image to enlarge) |
||
 |
 |
 |
| Trailing edges micro'd. | View of hard point hinge and push rod attachment tab at root of flaps. Trailing edge micro sanded. Soon to be BID. | |
 |
 |
 |
| Slight problem. The cores were a little thin. So here is the progress of making them thicker. I used templates to determine the thickness at various lengths, then micro'd a bead and sanded. | Next filled with two part urethane foam. | Sand the foam back to the micro guides. |
 |
 |
 |
| The a layer of BID was wrapped around the edge. The weave was filled with micro. | Flaps, finally filled and sanded. This is the first coat of primer. | |
 |
 |
 |
| Tops of flaps. | Bottom of flaps. I like them. | Right flap mounted. Hinges bonded in place. |