| HS Antennas | |
|
Plans and the parts for adding copper foil type antennas can be purchased
from
RST Engineering. The individual parts can also be purchased from
Wicks Aircraft Supply. The antennas below were added as a new builder. In hindsight they should be bonded to the skins. These will probably work but would be better if bonded to the skin. |
|
 |
Vor/Loc 1 antenna |
 |
Glide slope antenna |
 |
Antennas put in place |
 |
Close up of ferrite balun |
 |
In hindsight the antenna cables should exit off center by 2". |
 |
Quick connects
added.
If possible run long lengths cable to the panel and do not cut if able. The fewer the breaks the better. |